Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Kia Rio built from 2001 to 2005 (Base, Cinco, LX).
Every 2001-2005 Kia Rio uses a 4X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Kia Rio (DC) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2001-2005 |
| Cinco | 2001-2005 |
| LX | 2001-2005 |
Wheel sizes Kia fitted to the 2001-2005 Kia Rio from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 13x5 +40 |
| 14x5 +39 |
| 14x5.5 +40 |
| 14x5.5 +46 |
| 15x5.5 +46 |
| 15x6 +40 |
| 16x6.5 +46 |
Widths and offsets with Verified Fitment on the 2001-2005 Kia Rio: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 13-15" | 5.5" | +28 to +50 |
| 13-15" | 6" | +34 to +44 |
Wider still: 13x7 +26 to +37; 14x7 +26 to +37; 15x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
The 2001-2005 Kia Rio (DC) uses a 4X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 13x5 +40; 14x5 +39; 14x5.5 +40; 14x5.5 +46; 15x5.5 +46; 15x6 +40; 16x6.5 +46.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 13" to 15" in diameter; see the size table for the offset range at each width.