Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Mazda Tribute built from 2008 to 2011 (i Sport, i Touring, i Grand Touring, s Touring, s Grand Touring, Hybrid).
Every 2008-2011 Mazda Tribute uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mazda Tribute (2nd Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| i Sport | 2008-2011 |
| i Touring | 2008-2011 |
| i Grand Touring | 2008-2011 |
| s Touring | 2008-2011 |
| s Grand Touring | 2008-2011 |
| Hybrid | 2008-2011 |
Wheel sizes Mazda fitted to the 2008-2011 Mazda Tribute from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +45 |
| 17x7 +45 |
| 17x7.5 +42 |
| 18x7.5 +42 |
| 18x8 +38 |
Widths and offsets with Verified Fitment on the 2008-2011 Mazda Tribute: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 7" | +28 to +50 |
| 16-18" | 7.5" | +34 to +44 |
Wider still: 16x8.5 +26 to +37; 17x8.5 +26 to +37; 18x8.5 +26 to +37 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll or pull fender lips, front camber bolts, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2008-2011 Mazda Tribute. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (trim front bumper cover / inner fender liner at full lock, roll or pull fender lips, front camber bolts, hub-centric rings if the wheel bore is larger)











The 2008-2011 Mazda Tribute (2nd Gen) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.
Factory sizes: 16x7 +45; 17x7 +45; 17x7.5 +42; 18x7.5 +42; 18x8 +38.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.