Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Mercedes-Benz Sprinter built from 2010 to 2018 (2500, 3500 (single rear wheel)).
Every 2010-2018 Mercedes-Benz Sprinter uses a 6X130 bolt pattern with a 84.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 84.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mercedes-Benz Sprinter (W906) and the model years each was sold. All of them share the 6X130 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| 2500 | 2010-2018 | 16x5.5 +51 16x6.5 +62 17x6.5 +62 |
| 3500 (single rear wheel) | 2010-2018 | See factory sizes below |
Wheel sizes Mercedes-Benz fitted to the 2010-2018 Mercedes-Benz Sprinter from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 16x5.5 +51 |
| 16x6.5 +54 |
| 16x6.5 +62 |
| 17x6.5 +62 |
Widths and offsets with Verified Fitment on the 2010-2018 Mercedes-Benz Sprinter: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 5.5" | +32 to +61 |
| 16-18" | 6" | +38 to +67 |
| 16-18" | 6.5" | +45 to +67 |
| 16-18" | 7" | +51 to +61 |
Wider still: 16x8 +43 to +54; 17x8 +43 to +54; 18x8 +43 to +54 fit with modifications (check load rating of replacement wheels, hub-centric rings (84.1 mm), check inner clearance to brakes and suspension, correct-length lug bolts for the wheel seat).
The 2010-2018 Mercedes-Benz Sprinter (W906) uses a 6X130 bolt pattern and a 84.1 mm center bore.
Factory sizes: 16x5.5 +51; 16x6.5 +54; 16x6.5 +62; 17x6.5 +62.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.