Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan 350Z built from 2009 to 2009 (Enthusiast, Touring, Grand Touring).
Every 2009 Nissan 350Z uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan 350Z (Z33) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Enthusiast | 2009 |
| Touring | 2009 |
| Grand Touring | 2009 |
Wheel sizes Nissan fitted to the 2009 Nissan 350Z from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8 +30 front / 18x8.5 +33 rear |
| 18x9 +30 front / 19x10 +30 rear |
Widths and offsets with Verified Fitment on the 2009 Nissan 350Z: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18-19" | 8" | +13 to +35 | — |
| 18-19" | 8.5" | +19 to +29 | +16 to +38 |
| 18-19" | 9" | — | +22 to +32 |
Wider still: 18x10 front — / rear +14 to +25; 19x10 front — / rear +14 to +25 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2009 Nissan 350Z. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.


Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












The 2009 Nissan 350Z (Z33) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x8 +30 front / 18x8.5 +33 rear; 18x9 +30 front / 19x10 +30 rear.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.