Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Nissan 350Z built from 2003 to 2008 (Base, Enthusiast, Performance, Touring, Track, Grand Touring, 35th Anniversary, NISMO).
Every 2003-2008 Nissan 350Z uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan 350Z (Z33) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2003-2008 | See factory sizes below |
| Enthusiast | 2003-2008 | 17x7.5 +30 front / 17x8 +33 rear |
| Performance | 2003-2005 | 18x8 +30 18x8 +30 front / 18x8.5 +33 rear |
| Touring | 2003-2008 | 17x7.5 +30 front / 17x8 +33 rear |
| Track | 2003-2006 | 18x8 +30 18x8 +30 front / 18x8.5 +33 rear 18x9 +30 front / 19x10 +30 rear |
| Grand Touring | 2005-2008 | See factory sizes below |
| 35th Anniversary | 2005 | 18x8 +30 18x8 +30 front / 18x8.5 +33 rear |
| NISMO | 2007-2008 | 18x9 +30 front / 19x10 +30 rear |
Wheel sizes Nissan fitted to the 2003-2008 Nissan 350Z from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7.5 +30 front / 17x8 +33 rear |
| 18x8 +30 |
| 18x8 +30 front / 18x8.5 +33 rear |
| 18x9 +30 front / 19x10 +30 rear |
Widths and offsets with Verified Fitment on the 2003-2008 Nissan 350Z: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 17-19" | 7.5" | +2 to +40 | — |
| 17-19" | 8" | +8 to +40 | -4 to +43 |
| 17-19" | 8.5" | +15 to +33 | +2 to +44 |
| 17-19" | 9" | +21 to +27 | +8 to +38 |
| 17-19" | 9.5" | — | +15 to +31 |
| 17-19" | 10" | — | +21 to +25 |
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18-19" | 8" | +8 to +40 | -4 to +40 |
| 18-19" | 8.5" | +15 to +33 | +2 to +44 |
| 18-19" | 9" | +21 to +27 | +8 to +38 |
| 18-19" | 9.5" | — | +15 to +31 |
| 18-19" | 10" | — | +21 to +25 |
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18-19" | 9" | +21 to +30 | — |
| 19" | 10" | — | +21 to +30 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2003-2008 Nissan 350Z. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.








Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)




















Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)




The 2003-2008 Nissan 350Z (Z33) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 17x7.5 +30 front / 17x8 +33 rear; 18x8 +30; 18x8 +30 front / 18x8.5 +33 rear; 18x9 +30 front / 19x10 +30 rear.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 17" to 19" in diameter; see the size table for the offset range at each width.