Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Murano built from 2003 to 2007 (S, SL, SE).
Every 2003-2007 Nissan Murano uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Murano (Z50) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| S | 2005-2007 |
| SL | 2003-2007 |
| SE | 2003-2007 |
Wheel sizes Nissan fitted to the 2003-2007 Nissan Murano from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x7.5 +35 |
Widths and offsets with Verified Fitment on the 2003-2007 Nissan Murano: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-22" | 7.5" | +18 to +40 |
| 18-22" | 8" | +24 to +34 |
Wider still: 18x9 +16 to +27; 19x9 +16 to +27; 20x9 +16 to +27; 21x9 +16 to +27; 22x9 +16 to +27 fit with modifications (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2003-2007 Nissan Murano. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll fender lips, trim plastic fender liners / bumper edges, camber bolts for wider, lower-offset wheels)







The 2003-2007 Nissan Murano (Z50) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x7.5 +35.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 22" in diameter; see the size table for the offset range at each width.