Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Xterra built from 2000 to 2004 (SE, XE, SE S/C, XE S/C).
Every 2000-2004 Nissan Xterra uses a 6X139.7 bolt pattern with a 100.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 100.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Xterra (WD22) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| SE | 2000-2004 |
| XE | 2000-2004 |
| SE S/C | 2002-2004 |
| XE S/C | 2002 |
Wheel sizes Nissan fitted to the 2000-2004 Nissan Xterra from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +40 |
| 16x7 +40 |
| 17x8 +40 |
Widths and offsets with Verified Fitment on the 2000-2004 Nissan Xterra: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 7" | +23 to +45 |
| 15-18" | 7.5" | +29 to +39 |
Wider still: 15x8.5 +21 to +32; 16x8.5 +21 to +32; 17x8.5 +21 to +32; 18x8.5 +21 to +32 fit with modifications (2-in leveling kit for 32-33 in tires, trim front bumper / air dam and inner fender liners, aftermarket upper control arms if leveled more than 2 in).
The 2000-2004 Nissan Xterra (WD22) uses a 6X139.7 bolt pattern and a 100.3 mm center bore.
Factory sizes: 15x7 +40; 16x7 +40; 17x8 +40.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.