Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Scion tC built from 2011 to 2016.
Every 2011-2016 Scion tC uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Scion tC (AGT20) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2011-2016 |
Wheel sizes Scion fitted to the 2011-2016 Scion tC from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x7.5 +39 |
| 19x8 +35 |
Widths and offsets with Verified Fitment on the 2011-2016 Scion tC: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-19" | 7.5" | +13 to +49 |
| 18-19" | 8" | +19 to +55 |
| 18-19" | 8.5" | +26 to +50 |
| 18-19" | 9" | +32 to +44 |
| 18-19" | 9.5" | +38 |
Wider still: 18x10 +11 to +38; 18x10.5 +18 to +31; 19x10 +11 to +38; 19x10.5 +18 to +31 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2016 Scion tC. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)









The 2011-2016 Scion tC (AGT20) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.
Factory sizes: 18x7.5 +39; 19x8 +35.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.