Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Tesla Model S built from 2012 to 2020 (60, 70D, 75D, 85, 85D, 90D, 100D, P85, P85+, P85D, P90D, P100D, Standard Range, Long Range, Performance).
Every 2012-2020 Tesla Model S uses a 5X120 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Tesla Model S (1st Gen) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| 60 | 2013-2015 | 19x8 +40 19x8.5 +35 20x8 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| 70D | 2015-2016 | 19x8 +40 19x8.5 +35 20x8 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| 75D | 2017-2019 | 19x8 +40 |
| 85 | 2012-2015 | 19x8 +40 19x8.5 +35 20x8 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| 85D | 2015 | 19x8 +40 20x8.5 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| 90D | 2016-2017 | 19x8 +40 19x8.5 +35 |
| 100D | 2017-2019 | 19x8 +40 |
| P85 | 2012-2014 | 19x8 +40 20x8.5 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| P85+ | 2013-2014 | 19x8 +40 20x8.5 +40 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| P85D | 2015 | 20x8.5 +40 20x8.5 +40 front / 20x10 +40 rear 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| P90D | 2016 | 20x8.5 +40 20x8.5 +40 front / 20x10 +40 rear 21x8.5 +40 21x8.5 +40 front / 21x9 +40 rear |
| P100D | 2017-2019 | 19x8 +40 |
| Standard Range | 2019 | See factory sizes below |
| Long Range | 2019-2020 | 19x8 +40 19x8.5 +35 |
| Performance | 2019-2020 | 19x8 +40 19x8.5 +35 |
Wheel sizes Tesla fitted to the 2012-2020 Tesla Model S from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 19x8 +40 |
| 19x8.5 +35 |
| 20x8 +40 |
| 20x8.5 +40 |
| 20x8.5 +40 front / 20x10 +40 rear |
| 21x8.5 +40 |
| 21x8.5 +40 front / 21x9 +40 rear |
Widths and offsets with Verified Fitment on the 2012-2020 Tesla Model S: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 19-21" | 8" | +23 to +46 | +4 to +50 |
| 19-21" | 8.5" | +29 to +39 | +10 to +56 |
| 19-21" | 9" | — | +16 to +51 |
| 19-21" | 9.5" | — | +23 to +44 |
| 19-21" | 10" | — | +29 to +38 |
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 20-21" | 8.5" | +29 to +40 | +10 to +50 |
| 20-21" | 9" | — | +16 to +51 |
| 20-21" | 9.5" | — | +23 to +44 |
| 20-21" | 10" | — | +29 to +38 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2012-2020 Tesla Model S. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












The 2012-2020 Tesla Model S (1st Gen) uses a 5X120 bolt pattern and a 64.1 mm center bore.
Factory sizes: 19x8 +40; 19x8.5 +35; 20x8 +40; 20x8.5 +40; 20x8.5 +40 front / 20x10 +40 rear; 21x8.5 +40; 21x8.5 +40 front / 21x9 +40 rear.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 19" to 21" in diameter; see the size table for the offset range at each width.