Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Tesla Model S built from 2021 to 2026 (Long Range, All-Wheel Drive, Plaid).
Every 2021-2026 Tesla Model S uses a 5X120 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Tesla Model S (1st Gen) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Long Range | 2021-2023 | 19x9.5 +40 front / 19x10.5 +45 rear 20x9.5 +40 front / 20x10.5 +45 rear 21x9.5 +40 front / 21x10.5 +45 rear |
| All-Wheel Drive | 2024-2026 | See factory sizes below |
| Plaid | 2021-2026 | 19x9.5 +40 front / 19x10.5 +45 rear 20x9.5 +40 front / 20x10.5 +45 rear 21x9.5 +40 front / 21x10.5 +45 rear |
Wheel sizes Tesla fitted to the 2021-2026 Tesla Model S from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 19x9.5 +40 front / 19x10.5 +45 rear |
| 20x9.5 +40 front / 20x10.5 +45 rear |
| 21x9.5 +40 front / 21x10.5 +45 rear |
Widths and offsets with Verified Fitment on the 2021-2026 Tesla Model S: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 19-21" | 9.5" | +33 to +46 | — |
| 19-21" | 10" | +39 to +40 | — |
| 19-21" | 10.5" | — | +34 to +46 |
| 19-21" | 11" | — | +40 |
Wider still: 19x11.5 front — / rear +31 to +34; 20x11.5 front — / rear +31 to +34; 21x11.5 front — / rear +31 to +34; 22x11.5 front — / rear +31 to +34 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2021-2026 Tesla Model S. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)
The 2021-2026 Tesla Model S (1st Gen) uses a 5X120 bolt pattern and a 64.1 mm center bore.
Factory sizes: 19x9.5 +40 front / 19x10.5 +45 rear; 20x9.5 +40 front / 20x10.5 +45 rear; 21x9.5 +40 front / 21x10.5 +45 rear.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 19" to 21" in diameter; see the size table for the offset range at each width.