Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Toyota Sienna built from 2011 to 2020 (Base, L, LE, SE, XLE, Limited).
Every 2011-2020 Toyota Sienna uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Sienna (XL30) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2011-2014 | See factory sizes below |
| L | 2015-2020 | 17x6.5 +45 17x7 +35 |
| LE | 2011-2020 | See factory sizes below |
| SE | 2011-2020 | 19x7 +35 |
| XLE | 2011-2020 | See factory sizes below |
| Limited | 2011-2020 | See factory sizes below |
Wheel sizes Toyota fitted to the 2011-2020 Toyota Sienna from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 17x6.5 +45 |
| 17x7 +35 |
| 18x7 +35 |
| 19x7 +35 |
Widths and offsets with Verified Fitment on the 2011-2020 Toyota Sienna: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-20" | 6.5" | +8 to +55 |
| 17-20" | 7" | +14 to +59 |
| 17-20" | 7.5" | +21 to +53 |
| 17-20" | 8" | +27 to +46 |
| 17-20" | 8.5" | +33 to +40 |
| Diameter | Width | Offset range |
|---|---|---|
| 19-20" | 7" | +14 to +45 |
| 19-20" | 7.5" | +21 to +51 |
| 19-20" | 8" | +27 to +46 |
| 19-20" | 8.5" | +33 to +40 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2011-2020 Toyota Sienna. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
























The 2011-2020 Toyota Sienna (XL30) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.
Factory sizes: 17x6.5 +45; 17x7 +35; 18x7 +35; 19x7 +35.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.