Volkswagen Jetta (Mk5) 2006-2010 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Volkswagen Jetta built from 2006 to 2010 (Value Edition, 2.5, S, SE, SEL, Wolfsburg Edition, TDI, TDI, GLI).

Fitment specs

Bolt pattern5X112
Center bore57.1 mm
Lug threadM14x1.5
Model years2006-2010
GenerationMk5

Every 2006-2010 Volkswagen Jetta uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Volkswagen Jetta (Mk5) and the model years each was sold. All of them share the 5X112 bolt pattern.

SubmodelYearsFactory wheel sizes
Value Edition2006See factory sizes below
2.52006-2007See factory sizes below
S2008-201016x6.5 +50
SE2008-201016x6.5 +50
SEL2008-201017x7 +54
Wolfsburg Edition2008-200917x7 +54
TDI2006See factory sizes below
TDI2009-2010See factory sizes below
GLI2006-201017x7 +54

Factory wheel sizes

Wheel sizes Volkswagen fitted to the 2006-2010 Volkswagen Jetta from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
16x6.5 +50
17x7 +54

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2006-2010 Volkswagen Jetta: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

Value Edition, 2.5, S, SE, TDI, TDI

DiameterWidthOffset range
16-19"6.5"+33 to +55
16-19"7"+39 to +49

Wider still: 16x8 +31 to +42; 17x8 +31 to +42; 18x8 +31 to +42; 19x8 +31 to +42 fit with modifications (roll rear fender lips, front camber bolts (strut-to-knuckle) for negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts (longer with spacers)).

SEL, Wolfsburg Edition, GLI

DiameterWidthOffset range
17-19"7"+39 to +54
17-19"7.5"+46 to +47

Wider still: 17x8 +31 to +42; 18x8 +31 to +42; 19x8 +31 to +42 fit with modifications (roll rear fender lips, front camber bolts (strut-to-knuckle) for negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts (longer with spacers)).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2006-2010 Volkswagen Jetta. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Value Edition, 2.5, S, SE, TDI, TDI

Modifications Required (roll rear fender lips, front camber bolts (strut-to-knuckle) for negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts (longer with spacers))

SEL, Wolfsburg Edition, GLI

Modifications Required (roll rear fender lips, front camber bolts (strut-to-knuckle) for negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts (longer with spacers))

FAQ

What is the bolt pattern of the 2006-2010 Volkswagen Jetta?

The 2006-2010 Volkswagen Jetta (Mk5) uses a 5X112 bolt pattern and a 57.1 mm center bore.

What size wheels came on the 2006-2010 Volkswagen Jetta from the factory?

Factory sizes: 16x6.5 +50; 17x7 +54.

What lug thread size does the 2006-2010 Volkswagen Jetta use?

Its wheel fasteners use a M14x1.5 thread.

What aftermarket wheel sizes fit the 2006-2010 Volkswagen Jetta without modifications?

Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.