How to Read a Wheel Size: Diameter, Width, Offset and Bolt Pattern

PG WHEELS ยท November 18, 2026

A wheel listing like 18x8.5 +35 5x114.3 CB73.1 packs five measurements into one line. Here is what each one means and which ones have to match your car.

18: diameter

The wheel's diameter in inches, measured where the tire sits. A bigger diameter needs a tire with a shorter sidewall to keep the same overall tire height, so your speedometer stays accurate and the tire clears the wheel well. Most cars can go up one or two inches from the factory size; smaller than the factory size may not clear the brakes.

8.5: width

The width in inches between the tire beads. Each width works with a range of tire widths, and a wider wheel takes up more room both inside (toward the suspension) and outside (toward the fender).

+35: offset (ET)

How far the mounting face sits from the wheel's centerline, in millimeters. Together with width, offset decides where the wheel sits in the wheel well. Our guide to wheel offset explains it in detail.

5x114.3: bolt pattern

The number of lug holes (5) and the diameter of the circle they sit on (114.3 mm). It has to match your hub exactly: there is no "close enough". Some wheels are drilled for two patterns, like 5x112 / 5x114.3.

CB73.1: center bore

The hole in the middle of the wheel, in millimeters. It must be the same as or larger than your hub. When it's larger, hub-centric rings fill the gap so the wheel centers on the hub.

Square and staggered

A square set uses the same size on all four corners; a staggered set lists a front size and a wider rear size, like 19x8.5 / 19x9.5. See staggered vs square for when each makes sense.

The quick check

  1. Bolt pattern: must match exactly.
  2. Center bore: same as or larger than your hub.
  3. Diameter, width and offset: within the range that clears your brakes, suspension and fenders.

Add your vehicle on any wheel page and every size is checked against those numbers for you, or browse our vehicle fitment guides.

← All guides