Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura NSX built from 2002 to 2005.
Every 2002-2005 Acura NSX uses a 5X114.3 bolt pattern with a 70.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura NSX (NA1/NA2) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| NSX-T | 2002-2005 |
Wheel sizes Acura fitted to the 2002-2005 Acura NSX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +55 front / 17x8.5 +60 rear |
| 17x7 +55 front / 17x9 +56 rear |
Widths and offsets with Verified Fitment on the 2002-2005 Acura NSX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 16-17" | 7" | +38 to +60 | — |
| 16-17" | 7.5" | +44 to +54 | — |
| 16-17" | 8.5" | — | +43 to +65 |
| 16-17" | 9" | — | +49 to +59 |
Wider still: 16x10 front — / rear +41 to +52; 17x10 front — / rear +41 to +52 fit with modifications (roll / pull rear fender lips, adjustable camber arms or camber plates, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2002-2005 Acura NSX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll / pull rear fender lips, adjustable camber arms or camber plates, hub-centric rings for aftermarket wheels)
The 2002-2005 Acura NSX (NA1/NA2) uses a 5X114.3 bolt pattern and a 70.1 mm center bore.
Factory sizes: 16x7 +55 front / 17x8.5 +60 rear; 17x7 +55 front / 17x9 +56 rear.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 17" in diameter; see the size table for the offset range at each width.