Honda CR-V (RE) 2007-2011 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Honda CR-V built from 2007 to 2011 (LX, EX, EX-L, SE).

Fitment specs

Bolt pattern5X114.3
Center bore64.1 mm
Lug threadM12x1.5
Model years2007-2011
GenerationRE

Every 2007-2011 Honda CR-V uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Honda CR-V (RE) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
LX2007-2011
EX2007-2011
EX-L2007-2011
SE2011

Factory wheel sizes

Wheel sizes Honda fitted to the 2007-2011 Honda CR-V from the factory. Offsets are ET in millimeters.

Factory size
17x6.5 +50
18x7 +50
18x8 +45
19x8.5 +42
20x9 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2007-2011 Honda CR-V: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
16-19"6.5"+33 to +55
16-19"7"+39 to +49

Wider still: 16x8 +31 to +42; 17x8 +31 to +42; 18x8 +31 to +42; 19x8 +31 to +42 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2011 Honda CR-V. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels)

FAQ

What is the bolt pattern of the 2007-2011 Honda CR-V?

The 2007-2011 Honda CR-V (RE) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.

What size wheels came on the 2007-2011 Honda CR-V from the factory?

Factory sizes: 17x6.5 +50; 18x7 +50; 18x8 +45; 19x8.5 +42; 20x9 +40.

What lug thread size does the 2007-2011 Honda CR-V use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 2007-2011 Honda CR-V without modifications?

Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.