Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Subaru WRX STI built from 2005 to 2007 (Base, Limited).
Every 2005-2007 Subaru WRX STI uses a 5X114.3 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Subaru WRX STI (GD) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2005-2007 |
| Limited | 2007 |
Wheel sizes Subaru fitted to the 2005-2007 Subaru WRX STI from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x8 +48 |
| 17x8 +53 |
| 18x8 +53 |
| 18x8.5 +48 |
Widths and offsets with Verified Fitment on the 2005-2007 Subaru WRX STI: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-18" | 8" | +36 to +58 |
| 17-18" | 8.5" | +42 to +52 |
Wider still: 17x9.5 +34 to +45; 18x9.5 +34 to +45 fit with modifications (roll and lightly pull rear fender lips, front camber bolts / rear camber arms for -1.5° or more, check strut and caliper clearance on low-offset wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2005-2007 Subaru WRX STI. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.


Modifications Required (roll and lightly pull rear fender lips, front camber bolts / rear camber arms for -1.5° or more, check strut and caliper clearance on low-offset wheels)












The 2005-2007 Subaru WRX STI (GD) uses a 5X114.3 bolt pattern and a 56.1 mm center bore.
Factory sizes: 17x8 +48; 17x8 +53; 18x8 +53; 18x8.5 +48.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.