Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Subaru WRX STI built from 2008 to 2014 (Base, Limited).
Every 2008-2014 Subaru WRX STI uses a 5X114.3 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Subaru WRX STI (GR/GV) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2008-2014 |
| Limited | 2011-2014 |
Wheel sizes Subaru fitted to the 2008-2014 Subaru WRX STI from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +55 |
| 17x8 +53 |
| 18x7.5 +55 |
| 18x8.5 +55 |
| 19x8.5 +55 |
| 20x9 +48 |
Widths and offsets with Verified Fitment on the 2008-2014 Subaru WRX STI: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-21" | 8.5" | +38 to +60 |
| 18-21" | 9" | +44 to +54 |
Wider still: 18x10 +36 to +47; 19x10 +36 to +47; 20x10 +36 to +47; 21x10 +36 to +47 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2008-2014 Subaru WRX STI. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.


Modifications Required (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger)












The 2008-2014 Subaru WRX STI (GR/GV) uses a 5X114.3 bolt pattern and a 56.1 mm center bore.
Factory sizes: 17x7 +55; 17x8 +53; 18x7.5 +55; 18x8.5 +55; 19x8.5 +55; 20x9 +48.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 21" in diameter; see the size table for the offset range at each width.