Toyota Corolla (E90) 1988-1992 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Toyota Corolla built from 1988 to 1992 (DX, LE).

Fitment specs

Bolt pattern4X100
Center bore54.1 mm
Lug threadM12x1.5
Model years1988-1992
GenerationE90

Every 1988-1992 Toyota Corolla uses a 4X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Toyota Corolla (E90) and the model years each was sold. All of them share the 4X100 bolt pattern.

SubmodelYearsFactory wheel sizes
DX1988-199213x5 +39
LE1988-199213x5 +39

Factory wheel sizes

Wheel sizes Toyota fitted to the 1988-1992 Toyota Corolla from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
13x5 +39
13x5 +45
14x5.5 +39
14x5.5 +45

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1988-1992 Toyota Corolla: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
13-15"5"+21 to +49
13-15"5.5"+28 to +50
13-15"6"+34 to +44

Wider still: 13x7 +26 to +37; 14x7 +26 to +37; 15x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).

FAQ

What is the bolt pattern of the 1988-1992 Toyota Corolla?

The 1988-1992 Toyota Corolla (E90) uses a 4X100 bolt pattern and a 54.1 mm center bore.

What size wheels came on the 1988-1992 Toyota Corolla from the factory?

Factory sizes: 13x5 +39; 13x5 +45; 14x5.5 +39; 14x5.5 +45.

What lug thread size does the 1988-1992 Toyota Corolla use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1988-1992 Toyota Corolla without modifications?

Bolt-on sizes run from 13" to 15" in diameter; see the size table for the offset range at each width.