Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Land Cruiser built from 1991 to 1997.
Every 1991-1997 Toyota Land Cruiser uses a 6X139.7 bolt pattern with a 106.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 106.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Land Cruiser (J80) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1991-1997 |
Wheel sizes Toyota fitted to the 1991-1997 Toyota Land Cruiser from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +8 |
| 16x8 +14 |
Widths and offsets with Verified Fitment on the 1991-1997 Toyota Land Cruiser: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 7" | -16 to +18 |
| 15-18" | 7.5" | -9 to +24 |
| 15-18" | 8" | -3 to +19 |
| 15-18" | 8.5" | +3 to +13 |
Wider still: 15x9.5 -5 to +6; 16x9.5 -5 to +6; 17x9.5 -5 to +6; 18x9.5 -5 to +6 fit with modifications (trim front bumper cover / fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).
The 1991-1997 Toyota Land Cruiser (J80) uses a 6X139.7 bolt pattern and a 106.1 mm center bore.
Factory sizes: 15x7 +8; 16x8 +14.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.