Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Land Cruiser built from 1988 to 1990.
Every 1988-1990 Toyota Land Cruiser uses a 6X139.7 bolt pattern with a 106.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 106.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Land Cruiser (J60) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1988-1990 |
Wheel sizes Toyota fitted to the 1988-1990 Toyota Land Cruiser from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x5.5 +0 |
| 15x7 -20 |
| 15x7 -10 |
| 16x5.5 +0 |
Widths and offsets with Verified Fitment on the 1988-1990 Toyota Land Cruiser: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 8.5" | -30 to -25 |
The 1988-1990 Toyota Land Cruiser (J60) uses a 6X139.7 bolt pattern and a 106.1 mm center bore.
Factory sizes: 15x5.5 +0; 15x7 -20; 15x7 -10; 16x5.5 +0.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.