Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura MDX built from 2017 to 2020 (Base, Technology, Advance, Entertainment, A-Spec, Sport Hybrid, PMC Edition).
Every 2017-2020 Acura MDX uses a 5X120 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura MDX (YD3) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2017-2020 |
| Technology | 2017-2020 |
| Advance | 2017-2020 |
| Entertainment | 2017-2020 |
| A-Spec | 2019-2020 |
| Sport Hybrid | 2017-2020 |
| PMC Edition | 2020 |
Wheel sizes Acura fitted to the 2017-2020 Acura MDX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8 +55 |
| 19x8 +55 |
| 20x8 +55 |
| 20x8.5 +50 |
| 21x9 +50 |
Widths and offsets with Verified Fitment on the 2017-2020 Acura MDX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-20" | 8" | +25 to +60 |
| 18-20" | 8.5" | +31 to +54 |
| 18-20" | 9" | +37 to +48 |
Wider still: 18x9.5 +31 to +41; 19x9.5 +31 to +41; 20x9.5 +31 to +41; 21x9.5 +31 to +41; 22x9.5 +31 to +41 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2017-2020 Acura MDX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)








The 2017-2020 Acura MDX (YD3) uses a 5X120 bolt pattern and a 64.1 mm center bore.
Factory sizes: 18x8 +55; 19x8 +55; 20x8 +55; 20x8.5 +50; 21x9 +50.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 18" to 20" in diameter; see the size table for the offset range at each width.