Acura MDX 2nd Gen (YD2) 2007-2013 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura MDX built from 2007 to 2013 (Base, Technology, Sport, Advance, Entertainment).

Fitment specs

Bolt pattern5X120
Center bore64.1 mm
Lug threadM14x1.5
Model years2007-2013
Generation2nd Gen (YD2)

Every 2007-2013 Acura MDX uses a 5X120 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Acura MDX (2nd Gen (YD2)) and the model years each was sold. All of them share the 5X120 bolt pattern.

SubmodelYears
Base2007-2013
Technology2007-2013
Sport2007-2009
Advance2010-2013
Entertainment2007-2013

Factory wheel sizes

Wheel sizes Acura fitted to the 2007-2013 Acura MDX from the factory. Offsets are ET in millimeters.

Factory size
18x8 +45
19x8.5 +45
19x9 +42
20x8.5 +45
20x10 +35

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2007-2013 Acura MDX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
18-19"8"+21 to +55
18-19"8.5"+27 to +49
18-19"9"+33 to +43

Wider still: 18x9.5 +19 to +44; 18x10 +25 to +38; 19x9.5 +19 to +44; 19x10 +25 to +38; 20x9.5 +19 to +44; 20x10 +25 to +38… fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2013 Acura MDX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)

FAQ

What is the bolt pattern of the 2007-2013 Acura MDX?

The 2007-2013 Acura MDX (2nd Gen (YD2)) uses a 5X120 bolt pattern and a 64.1 mm center bore.

What size wheels came on the 2007-2013 Acura MDX from the factory?

Factory sizes: 18x8 +45; 19x8.5 +45; 19x9 +42; 20x8.5 +45; 20x10 +35.

What lug thread size does the 2007-2013 Acura MDX use?

Its wheel fasteners use a M14x1.5 thread.

What aftermarket wheel sizes fit the 2007-2013 Acura MDX without modifications?

Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.