Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Nissan Maxima built from 1989 to 1994 (GXE, SE).
Every 1989-1994 Nissan Maxima uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Maxima (J30) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| GXE | 1989-1994 | 15x6 +40 15x6.5 +40 |
| SE | 1989-1994 | See factory sizes below |
Wheel sizes Nissan fitted to the 1989-1994 Nissan Maxima from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +40 |
| 15x6.5 +40 |
Widths and offsets with Verified Fitment on the 1989-1994 Nissan Maxima: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-16" | 6" | +23 to +46 |
| 15-16" | 6.5" | +29 to +39 |
Wider still: 15x7.5 +21 to +32; 16x7.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
The 1989-1994 Nissan Maxima (J30) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 15x6 +40; 15x6.5 +40.
Bolt-on sizes run from 15" to 16" in diameter; see the size table for the offset range at each width.