Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Maxima built from 1995 to 1999 (GLE, GXE, SE).
Every 1995-1999 Nissan Maxima uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Maxima (A32) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| GLE | 1995-1999 |
| GXE | 1995-1999 |
| SE | 1995-1999 |
Wheel sizes Nissan fitted to the 1995-1999 Nissan Maxima from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +40 |
| 15x6.5 +45 |
| 16x6.5 +45 |
Widths and offsets with Verified Fitment on the 1995-1999 Nissan Maxima: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +23 to +46 |
| 15-17" | 6.5" | +29 to +39 |
Wider still: 15x7.5 +21 to +32; 16x7.5 +21 to +32; 17x7.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
The 1995-1999 Nissan Maxima (A32) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 15x6 +40; 15x6.5 +45; 16x6.5 +45.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.