Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Maxima built from 2004 to 2008 (SE, SL).
Every 2004-2008 Nissan Maxima uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Maxima (A34) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| SE | 2004-2008 |
| SL | 2004-2008 |
Wheel sizes Nissan fitted to the 2004-2008 Nissan Maxima from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +50 |
| 17x7 +35 |
| 17x7 +55 |
| 18x7.5 +40 |
| 18x7.5 +50 |
Widths and offsets with Verified Fitment on the 2004-2008 Nissan Maxima: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-18" | 7" | +18 to +45 |
| 17-18" | 7.5" | +24 to +51 |
| 17-18" | 8" | +31 to +48 |
Wider still: 17x8.5 +16 to +47; 17x9 +23 to +41; 18x8.5 +16 to +47; 18x9 +23 to +41 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2004-2008 Nissan Maxima. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.







Modifications Required (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger)








The 2004-2008 Nissan Maxima (A34) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 16x6.5 +50; 17x7 +35; 17x7 +55; 18x7.5 +40; 18x7.5 +50.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.