Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the BMW M3 built from 1988 to 1991.
Every 1988-1991 BMW M3 uses a 5X120 bolt pattern with a 72.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 72.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the BMW M3 (E30) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1988-1991 |
Wheel sizes BMW fitted to the 1988-1991 BMW M3 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +30 |
| 16x7.5 +27 |
Widths and offsets with Verified Fitment on the 1988-1991 BMW M3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 7" | +13 to +36 |
| 15-17" | 7.5" | +19 to +29 |
Wider still: 15x8.5 +11 to +22; 16x8.5 +11 to +22; 17x8.5 +11 to +22 fit with modifications (roll front and rear fender lips, front camber plates for low offsets, hub-centric rings if wheel bore is larger than the hub).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1988-1991 BMW M3. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber plates for low offsets, hub-centric rings if wheel bore is larger than the hub)
The 1988-1991 BMW M3 (E30) uses a 5X120 bolt pattern and a 72.6 mm center bore.
Factory sizes: 15x7 +30; 16x7.5 +27.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.