Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the BMW M3 built from 1995 to 1999.
Every 1995-1999 BMW M3 uses a 5X120 bolt pattern with a 72.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 72.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the BMW M3 (E36) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1995-1999 |
Wheel sizes BMW fitted to the 1995-1999 BMW M3 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +41 |
| 17x7.5 +41 |
| 17x7.5 +41 front / 17x8.5 +41 rear |
Widths and offsets with Verified Fitment on the 1995-1999 BMW M3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 15-17" | 7.5" | +24 to +44 | +11 to +51 |
| 15-17" | 8" | +30 to +38 | +18 to +50 |
| 15-17" | 8.5" | — | +24 to +44 |
| 15-17" | 9" | — | +30 to +38 |
Wider still: 15x9.5 front +18 to +24 / rear +8 to +40; 15x10 front — / rear +14 to +34; 15x10.5 front — / rear +21 to +27; 16x9.5 front +18 to +24 / rear +8 to +40; 16x10 front — / rear +14 to +34; 16x10.5 front — / rear +21 to +27… fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1995-1999 BMW M3. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)










The 1995-1999 BMW M3 (E36) uses a 5X120 bolt pattern and a 72.6 mm center bore.
Factory sizes: 17x7 +41; 17x7.5 +41; 17x7.5 +41 front / 17x8.5 +41 rear.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.