Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the BMW M3 built from 2001 to 2006.
Every 2001-2006 BMW M3 uses a 5X120 bolt pattern with a 72.6 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 72.6 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the BMW M3 (E46) and the model years each was sold. All of them share the 5X120 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2001-2006 |
Wheel sizes BMW fitted to the 2001-2006 BMW M3 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7.5 +47 front / 17x7.5 +25 rear |
| 17x7.5 +41 front / 17x8.5 +50 rear |
| 18x7.5 +41 front / 18x7.5 +25 rear |
| 18x8 +47 front / 18x9 +26 rear |
| 19x8 +47 front / 19x9.5 +27 rear |
Widths and offsets with Verified Fitment on the 2001-2006 BMW M3: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18" | 8" | +29 to +54 | — |
| 18" | 8.5" | +35 to +47 | — |
| 18" | 9" | — | +16 to +36 |
| 18" | 9.5" | — | +22 to +31 |
Wider still: 18x10 front — / rear +14 to +34; 18x10.5 front — / rear +21 to +27 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2001-2006 BMW M3. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)



The 2001-2006 BMW M3 (E46) uses a 5X120 bolt pattern and a 72.6 mm center bore.
Factory sizes: 17x7.5 +47 front / 17x7.5 +25 rear; 17x7.5 +41 front / 17x8.5 +50 rear; 18x7.5 +41 front / 18x7.5 +25 rear; 18x8 +47 front / 18x9 +26 rear; 19x8 +47 front / 19x9.5 +27 rear.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 18" to 18" in diameter; see the size table for the offset range at each width.