Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Mazda MX-5 Miata built from 2006 to 2006 (Club Spec, Sport, Touring, Grand Touring, 3rd Generation Limited).
Every 2006 Mazda MX-5 Miata uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Mazda MX-5 Miata (NC) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Club Spec | 2006 | 16x6.5 +55 |
| Sport | 2006 | 17x7 +55 |
| Touring | 2006 | 16x6.5 +55 |
| Grand Touring | 2006 | 17x7 +55 |
| 3rd Generation Limited | 2006 | See factory sizes below |
Wheel sizes Mazda fitted to the 2006 Mazda MX-5 Miata from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +55 |
| 17x7 +55 |
Widths and offsets with Verified Fitment on the 2006 Mazda MX-5 Miata: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 16-18" | 6.5" | +38 to +60 | +31 to +60 |
| 16-18" | 7" | +44 to +54 | +38 to +54 |
| 16-18" | 7.5" | — | +44 to +48 |
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 17-18" | 7" | +44 to +55 | +38 to +55 |
| 17-18" | 7.5" | — | +44 to +48 |
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2006 Mazda MX-5 Miata. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger)


Modifications Required (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger)
The 2006 Mazda MX-5 Miata (NC) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.
Factory sizes: 16x6.5 +55; 17x7 +55.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.