Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota 4Runner built from 1996 to 2002 (Base, SR5, Limited).
Every 1996-2002 Toyota 4Runner uses a 6X139.7 bolt pattern with a 106.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 106.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota 4Runner (N180) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1996-2000 |
| SR5 | 1996-2002 |
| Limited | 1996-2002 |
Wheel sizes Toyota fitted to the 1996-2002 Toyota 4Runner from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +15 |
| 16x7 +15 |
Widths and offsets with Verified Fitment on the 1996-2002 Toyota 4Runner: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 7" | -2 to +21 |
| 15-18" | 7.5" | +4 to +14 |
Wider still: 15x8.5 -4 to +7; 16x8.5 -4 to +7; 17x8.5 -4 to +7; 18x8.5 -4 to +7 fit with modifications (trim front bumper cover / fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).
The 1996-2002 Toyota 4Runner (N180) uses a 6X139.7 bolt pattern and a 106.1 mm center bore.
Factory sizes: 15x7 +15; 16x7 +15.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.