BMW 7 Series (E32) 1988-1994 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the BMW 7 Series built from 1988 to 1994 (735i, 735iL, 740i, 740iL, 750iL).

Fitment specs

Bolt pattern5X120
Center bore72.5 mm
Lug threadM12x1.5
Model years1988-1994
GenerationE32

Every 1988-1994 BMW 7 Series uses a 5X120 bolt pattern with a 72.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 72.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the BMW 7 Series (E32) and the model years each was sold. All of them share the 5X120 bolt pattern.

SubmodelYearsFactory wheel sizes
735i1988-199215x7 +20
735iL1988-199215x7 +20
740i1993-199415x7 +20
740iL1993-199415x7 +20
750iL1988-199415x7 +20

Factory wheel sizes

Wheel sizes BMW fitted to the 1988-1994 BMW 7 Series from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
15x7 +20

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1988-1994 BMW 7 Series: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-16"7"+3 to +26
15-16"7.5"+9 to +19

Wider still: 15x8.5 +1 to +12; 16x8.5 +1 to +12 fit with modifications (roll rear fender lips, adjustable rear camber arms for -1.5° or more, front camber plates, hub-centric rings if wheel bore is larger than the hub).

FAQ

What is the bolt pattern of the 1988-1994 BMW 7 Series?

The 1988-1994 BMW 7 Series (E32) uses a 5X120 bolt pattern and a 72.5 mm center bore.

What size wheels came on the 1988-1994 BMW 7 Series from the factory?

Factory sizes: 15x7 +20.

What lug thread size does the 1988-1994 BMW 7 Series use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1988-1994 BMW 7 Series without modifications?

Bolt-on sizes run from 15" to 16" in diameter; see the size table for the offset range at each width.