Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford F-150 built from 1987 to 1991 (Custom, S, XL, XLT, XLT Lariat, Nite).
Every 1987-1991 Ford F-150 uses a 5X139.7 bolt pattern with a 87.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 87.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford F-150 (8th Gen) and the model years each was sold. All of them share the 5X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Custom | 1987-1991 |
| S | 1990-1991 |
| XL | 1987-1991 |
| XLT | 1987-1991 |
| XLT Lariat | 1987-1991 |
| Nite | 1991 |
Wheel sizes Ford fitted to the 1987-1991 Ford F-150 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +0 |
| 15x7 +10 |
Widths and offsets with Verified Fitment on the 1987-1991 Ford F-150: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-20" | 6" | -17 to +5 |
| 15-20" | 6.5" | -11 to -1 |
Wider still: 15x7.5 -19 to -8; 16x7.5 -19 to -8; 17x7.5 -19 to -8; 18x7.5 -19 to -8; 19x7.5 -19 to -8; 20x7.5 -19 to -8 fit with modifications (leveling kit (about 2 in) or lift for larger tires, trim front bumper valance, mud flaps and plastic fender liner, body mount chop (bmc) for very low / negative offsets).
The 1987-1991 Ford F-150 (8th Gen) uses a 5X139.7 bolt pattern and a 87.1 mm center bore.
Factory sizes: 15x6 +0; 15x7 +10.
Its wheel fasteners use a 1/2"-20UNF thread.
Bolt-on sizes run from 15" to 20" in diameter; see the size table for the offset range at each width.